Spicer Wheel Differential Bearing Replacement Process Bedienungsanleitung PDF herunterladen

Spicer

Drive Axles

P/N: SHAIS183

Wheel Differential Bearing Replacement Process

This procedure should only be followed if a wheel differential bearing cup has been identified as having a cup

that has rotated. It is important that this procedure is followed to insure a proper repair. Refer to Dana Service

Manual AXSM-0056 for any additional carrier set-up information.

Effected Axle Models: D170D/D190D

Parts Needed:

1- 131048 – Threaded bearing cup, plain half – diff. lock

1- 131044 – Threaded bearing cup, flange half

1- 512896 – Forward axle, carrier to housing hardware kit

1- 512897 – Rear-rear axle, carrier to housing hardware kit

1- Loctite 540 ( blue )

1- 513061 – Adjusting tool

Instructions:

Block the front and back of one of the steer axle tires.

2. Drain the axle lubricant into a clean container. This lube will be reused after this repair.

3. Disconnect drive shaft from yoke

4. Disconnect IAD lock out and or wheel differential lock out air lines.

5. Remove axle shaft nuts, washers and the axle shafts.

6. Remove carrier to housing capscrews and discard.

7. Place the carrier assembly in a head stand if available.

8. Measure and record ring gear backlash. We will be setting the backlash back to this setting during reassembly.

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Drive Axles

Spicer® Drive Axles P/N: SHAIS183 Wheel Differential Bearing Replacement Process This procedure should only be foll

Seite 2

9. Now remove the carrier cap capscrews and carrier caps from the plain half and flange half sides. 10. Using the wheel diff. bearing adju

Seite 3

12. Use a rag and solvent to clean the threads of the carrier cap and carrier bore. Also clean the threads of the flange half side threaded adjuster

Seite 4

17. Use a ratchet or breaker bar and a 1 ¼” deep wall socket to turn the flange half threaded bearing cup in until the ring gear contacts the pinio

Seite 5 - 1/8” Bead Center

20. Use a rubber mallet to fully seat the threaded bearing cups. 21. With a dial indicator, check

Seite 6

24. Install the carrier differential bearing caps and capscrews. Make curtain there is no gap between the carrier cap and the carrier surface.

Seite 7

29. It is important that the stake depth is deep enough to enter the machined slot in the carrier housing. There will be a 1/6” space between the

Seite 8

35. Torque carrier to housing capscrews to the chart below. Axle Location Dana Kit Part Number Fastener Type N.m Ibs-ftForward 512896 Capscrew and

Kommentare zu diesen Handbüchern

Keine Kommentare

Spicer Wheel Differential Bearing Replacement Process Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Spicer Wheel Differential Bearing Replacement Process herunter. Spicer Wheel Differential Bearing Replacement Process User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Spicer Wheel Differential Bearing Replacement Process