Spicer S190 Installation Bedienungsanleitung PDF herunterladen

Spicer

Axles & Brakes

P/N: SHAIS155

Installation Instruction and Torque Requirements

For Axle Housing Hardware Kit – D170/S170 and D190/S190

Shown below are torque specifications and installation procedure for the axle housing hardware parts included in this kit.

General Hardware Fastener Installation Instructions:

1. Block vehicle tires and disconnect driveline.

2. Drain axle lube and remove axle shafts.

3. Remove old carrier fasteners and carrier assembly.

4. Before installing new fastener hardware or the carrier assembly, the axle housing should be visually inspected for

cracks, nicks or burrs on all machined surfaces. Clean the threaded boltholes in the axle housing, removing any paint,

old sealant or oil from the housing and carrier mounting surfaces. Studs need to be replaced only if the stud came out

with the nut at the time of disassembly.

5. Apply a 1/8” bead of approved RTV sealant to the housing surface; it’s important to apply the sealant around (make a

loop) all of the threaded boltholes. Reinstall the carrier assembly.

6. Install new fasteners supplied in kit.

7. Torque the capscrew or nut to the correct specification listed in the chart below. If installing studs be sure to install

them to the proper specification outlined below.

Installation Instructions: Carrier-to-Housing Studs

Install carrier-to-housing studs into housing until 2 full threads is visible, being careful not to drive or install it too far.

The stud should extend out from the face of the housing approximately 1-11/16” (43mm)

Important! Dana does not recommend mixing old and new carrier fasteners on the same carrier. If reusing

old fasteners, use Loctite® 277 or 271 (which is red in color) on the threads of the old fastener and torque to

correct specification. Final torque values of hardware fasteners must be measured using a calibrated torque

wrench.

Axle Model Part No. Location Class Size Length lbs. Ft. N.m

D40-170, D40-170D, D46-

170, D46-170D, D50-170,

131106 Carrier to Housing - Long 10.9 M16X1.5 85mm 250-275 339-373

D52-190, D52-190D, D60-

190, S21-170, S21-170D,

131105 Carrier to Housing - Short 10.9 M16X1.5 55mm 250-275 339-373

S23-170, S23-170D, S23-190,

S23-190D, S26-190, S26-

190D, S30-190

127567 Carrier to Housing - Nut 12 M16X1.5 N/A 210-230 285-311

Torque Specification Chart

1 2

Spicer 1

Inhaltsverzeichnis

Seite 1 - Spicer

Spicer® Axles & Brakes P/N: SHAIS155 Installation Instruction and Torque Requirements For Axle Housing Hardware Kit –

Seite 2

Installation Instruction and Torque Requirements For Axle Housing Hardware Kit Capscrew & Stud Fastener Locations for Dana D170/S170 Single Axle

Kommentare zu diesen Handbüchern

Keine Kommentare

Spicer S190 Installation Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Spicer S190 Installation herunter. Spicer S190 Installation User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Spicer S190 Installation